Stamping Bella Wonderful Wednesday - Hello Chatty

 Hi I am here with my Stamping Bella Wonderful Wednesday post. I had lots of fun 

creating this one the hardest part was choosing the colours as I wanted

to create her in ever colour so I think I might just have to create a few more😉

 Today I have used the largest  Rubber Stamp of Chatty Squidgy she is also

 available as a "CUT IT OUT" die or as a BUNDLE (Rubber Stamp

and "Cut It Out" Die) where you save 15% when purchased together.

So first of all I coloured Chatty up using Copics.

Face - E0000, E000, E00, E01, E11, R20

Hair - E40, E42, E43, E44

Belt, Shoes - C0, C01, C05, N07, N09

Phone - BG10, BG11, BG13, BG45

Dress, Ribbon, Soles of Shoes - Y11, Y15, Y18, YR23

So to create this card I layered black cardstock and a designer paper

on a white card base. Then on a layer the same size as the designer 

paper in white I cut out the  MFT Big Hello  and cut a scallop

edge with SSS Wavy Scallop Stitches die . 

I then covered the back with acetate and 3M tape around the whole section 

and the hello to create a shaker card section.

I then Popped sequins in it and covered the back with yellow

designer paper.

I put it all together and scattered some sequins around. I couldn't fussy cut

around the phone cord so I replaced it with some really lovely  black thread.

It would have been so much easier if I had bought a "CUT IT OUT" die

at the start  😋. 

Ssssh don't tell but the other problem I had I coloured her shoes to dark

so I restamped,  coloured, fussy cut and glued them on and they worked

 beautifully because the rest of her I was really happy with.

I hope you enjoyed this card and Happy Crafting.

Jennifer

The Rubber Buggy - Rabbit, Flower, Butterfly

Hi I am here  with Tuesday's post for
The Rubber Buggy
I am still waiting

on the Postie with all my new goodies to create with I 

will keep my fingers crossed and hopefully they will be

here before next week to share with you all.

So this week I used this really Cute Stamp

 Wild Rose Studio Bunny and Butterfly.  I have

created this background by wiping Distress Ink Pads on a
Tim Holtz Mat.I used Picked Raspberry, Dusty Concord and
Wilted Violet inks on a mat and spraying 2 squirts of water on
 each colour. I then smoosh my papers in them  drying inbetween
each layer and building up until its the right depth. I did it quiet

dark. I then sprayed it using Tim Holtz Perfect Pearls

As you can see by the Memory Box Distressed Addington Die

I only needed one corner with colour. I then diecut it from 

White Card Stock and used 3D Foam Tape around the edges and a

 couple of strips down the center for support and taped it too the 

coloured piece. You could use any of the Memory Box Dies with

an open pattern to do this with.

I then stamped the Butterfly only making sure I didn't get ink on

 the rabbit. I coloured it roughly. I then stamped another two

butterflies and fussy cut the butterfly wings one altogether and 

the other with only the top wing. I coloured them and then  covered

them in Wink of Stella Clear. I then layered each

one using 3D foam squares.

I then sprinkled a few clear sequin around. I then stamped

and fussycut the Rabbit and used 3D Tape to pop him on.

I also layered it on a white card base with an aqua layer.

All these products and more are available at the

The Rubber Buggy Shop and don't forget to visit us on Facebook 
 look for the Videos down the side too, Instragram and the 
Rubber Buggy Design Team Blog where there's a post nearly
 everyday from one of the team.

Happy Crafting

Jennifer

La-La Land Crafts - Colour Inspiration

Hi it's Monday and hope you all had some wonderful sunshine on your weekend.

Well I am here with the theme for 

La-La Land Crafts

and it is a 

Photo/Colour Inspiration 

 I have used  Cool Beans Luka  and inlayed the Happy for

a great effect.

                    

Stamp 
 Cool Beans Luka
Dies
Coffee Cup
 Donut
Happy

Copics
Face - E0000, E000, E00, E01, E11, R20
Hair - E30, E33, E50
Beanie, Shirt, Shoes - YR07, YR09, YR23, E33
Cup - C01, C02, N5
Pants, Jacket, Soles of Shoes - E70, E71, E74, E79

 Also don't forget to join in all the La-La Land Crafts fun by adding

your creations to our Facebook page . Also for more Inspiration we are on Twitter , Pinterest and Instagram too.

Happy Crafting Everyone

Jennifer

La-La Land Crafts - Diorama Card Tutorial

Hi I am here with La-La Land Crafts for Tutorial Thursday. I am going to

show you how to create a Diorama Card.

First I cut 3 pieces of card stock the same 9 inches x 4 3/4 inches.
I scored at 1 3/4 Inches and 7 1/4 inches.
I then cut out those 2 corners cutting down from the top 1/2 an inch.

Then using the Large Fancy Bracket Die  I cut the top as in the

picture below to all three pieces.

I used the photo die from Photo Elements to cut out the centre

for our card it was about half an inch from the bottom and centered.

Only do this to two of your pieces.

So two of them look like this.

Then one of the two pieces I cut 1/2 an inch off each side.

So to decorate it I did one layer at a time. This is the back the piece

without the hole. I used the Island Die and Double Stitched Hills Border.

This is the one we cut the 1/2 inch of the sides which is our middle

layer. I popped a piece of acetate on the back of the hole as the 

Koi Circle wasn't strong enough another thing I could of used is

the Chipboard diecut with the Koi Circle and not put the acetate there.

I used Spring Blossoms Small layering a yellow and white.

I coloured my pearls with a yellow copics for the center.

The Waves Die was perfect for this card. I used these adorable

Dolphins from Oceans Of Joy.

This is the front I used the Floral Pocket dies on the sides and

on the front Summer Vacation Marci and another of the dolphins.

The flowers are a mix of Spring Blossoms Small and 

Spring Blossoms. For the top of the card the Aqua Strip is cut using

the Fancy Brackets.

I also decided I needed another wave so I cut a 9 inch strip 1/2 an

 inch wide and scored at 1 3/4 and 7 1/4 I then cut of each end 

1/2 an inch.

Ok to put it all together I taped the the edges of the 1/2 inch strip 

and center piece and stuck it to the inside flaps of the back 

making sure the bottoms are all straight.

The front then goes on the outside of the back side flaps.

They do fold flat for an envelope to send. 

 Here is another one I created.

A side look.

 Also don't forget to join in all the La-La Land Crafts fun by adding

your creations to our Facebook page . Also for more Inspiration we are on Twitter , Pinterest and Instagram too.

Happy Crafting Everyone

Jennifer

Stamping Bella - Daisy Border Shaker

Daisy

Hi I am here for Stamping Bella 's Wonderful Wedensday and today

I have used a fun Border Shaker  on my Card. Think I might be 

finding myself doing some more of these. 

 I have used this Very Very adorable Rubber Stamp DAISY SQUIDGY

 and she is also available as a "CUT IT OUT" and BUNDLE where you

 save 15% when purchased together. 

 I have used the biggest DAISY

Stamp and stamped her on the second biggest MFT inside/out rectangle 

 and coloured her up with copics

Copics

Face - E0000, E000, E00, E01, E11, R20

Hair - E40, E41, E43, E44

Dress, Shoes - BG11, BG13, BG45, BG49

Flower Stem - YG11, G21, G63

Flower - C0, C01, C02

Flower Center - Y11, Y15, Y18, YR23, E35

I then cut out the largest MFT Rectangle Scallop Frame. Cut a piece of 

acetate to cover it and stuck them together. I taped Daisy to the outside of

 the acetate in the centre. 

Then on the back as in the pic below I placed

my 3M tape around the frame and around Daisy.

I then filled the outside with sequins.

I then put a piece of yellow designer paper to hold them in the same size as the acetate.

I then layered that on aqua design paper and a white card base.

I have not put a sentiment on her yet  as I thought she can be used for so

many, Thankyou, Birthday, Hi etc.

I hope you enjoyed this really cute card.

See you next week

Happy Crafting

Jennifer

The Rubber Buggy Magical Christmas Faries

 Hi I am here for The Rubber Buggy  with a Christmas in July

Card I am trying to be a little bit organized this year.

Just a reminder too take a look at all the amazing

What's New section of goodies in the shop and on Preorder.

I have a nice bundle comming so cann't wait to get it and create 

for you.

So I have done a Border Shaker Card using

LF Fancy Scalloped Rectangles the largest and largest

LF Stitched 4 Bar Rectangles also. I cut the frame.

I added acetate to the back and diecut 

LF Small 4 Bar Stitched Rectangle and  added 3 clouds

one of each of the LF Puffy Cloud. 1 in card stock and the other 

2 in velum layered to look good. I also cut them out using the

center rectangle die and the glued them on. Papers used are

LF Perfectly Plaid 6x6 the sequins are a mix from all the

newly stocked range of Sequins. I have created a shaker card

using the 3D Tape around the edge of the image piece

that I taped to the center of the acetate and the frame. The stamps I 

used were all from Lawn Fawn Frosty Fairy Friends.

All these products and more are avaliable at the

The Rubber Buggy Shop and don't forget to visit us on Facebook 
 look for the Videos down the side too, Instragram and the 
Rubber Buggy Design Team Blog where there's a post nearly
 everyday from one of the team.

Happy Crafting

Jennifer

La-La Land Crafts - May 2017 Kit

 

Hi Everyone hope you all had a lovely weekend and a long one

if you got the Queens Birthday off.

I am here with the May 2017 Kit and isn't

it a really fun one.

For all your Kit info head HERE.

I have used it to create two 3D Cards I am not sure what sort of

card the first one is but the second is a Mini Box Card Tutorial

 and they all worked so well with both designs.

Old Dies 

Stitched Nestered Circles 
Copics
Face - E0000, E000, E00, E01, E11, R20
Hair - E40, E42, E43, E44
Leggins, Pockets, Headband, Hair Ties - Y15, Y18, YR23, E33
Lolly Pop - R35, R37, R39
Shoes, Top - G16, G19, G28

Copic
Pig -
Pig - R00, R01, R02
Belt, Balloon, Ballet Shoes - R32, R35, R37, R39
Tu Tu -BG02, BG05, BG07
Mini Marci -
Face - E0000, E000, E00, E01, E11, R20
Hair - E40, E42, E43, E44
Headband, Pockets, Pants - BG05, BG07, BG09, BG18
Dress - R32, R35, R37, R39
Monkey -
Fur - E40, E42, E43, E44
Tummy Inside Ears and Tummy - E30, E31, E33
Top Hat - BG05, BG07, BG09, BG18
Hat Band - C03, C05, C07, C09

 Also don't forget to join in all the La-La Land Crafts fun by adding

your creations to our Facebook page . Also for more Inspiration we are on Twitter , Pinterest and Instagram too.

Happy Crafting Everyone

Jennifer