The Rubber Buggy - Memory Box Christmas

Hi I am here for
The Rubber Buggy
 with a card for Christmas in July.

So today I will show you how I made this Shaker Card.

I used 3 of the Memory Box Dies.  I cut 3 squares 10cm x 10cm and Die Cut

one of each.

Next I cut 2 white and 2 Aqua Christmas's from another Memory Box Die.

I then Created the frame using the Outside In Stitched Scalloped Rectangle and

did a partial cut and created a square I then cut the centre out using the

 4Bar Stitched Rectangle partial die cutting too. Squares are on my wishlist
and will make it a lot easier to create.

Then to create it I Glued the frame onto the deers. I then cut a 10cm x 10cm  

piece of acetate and glued it behind the deers. I then glued the trees 

behind the deers . On this layer I used 3D tape all around and rest under 

the snow line too and placed some sequins in there. For the back I cut a piece

of Aqua 10cm x 10cm and glued the mountains on it.  I then attached  this on the

 back off the shaker section I then made a base Card and glued it on. I layered the
 two white on the two Aqua Christmas' off centre and glued them on the card.     

Card Complete but you could use any of the different Memory Box Christmas Dies

in this style and layer them in different ways.

Lawn Fawn 4 Bar Die

Stitched Mountains

Stitched Circle of Trees

Deer Family Circle

Merry Christmas

Bazzill

Hope you all have a Great Crafting Week

Jennifer